Quartz stone is widely used in kitchen countertops, Laboratory countertops, and windowsills, have to say that the kitchen seems to become synonymous with quartz. A lot of people will say that quartz stone is the exclusive kitchen countertop, this view is wrong. Quartz stone was first applied to the table because manufacturers are limited in the production technology and capacity of quartz, most of them rely on imports, leading to the high price of quartz stone so that ordinary income families can only choose to apply in the kitchen with relatively high requirements on the countertop.
Quartz stone manufacturers with the improvement of production technology and capacity, quartz stone has been fully used in the overall home decoration. Because the quartz stone water absorption rate is very low, the surface is smooth and difficult to paste, if the traditional cement mortar bonding paste, improper treatment is prone to water spots, discoloration, resulting in more hollow than natural stone, cracking, falling off, bulging and other problems.
Quartz stone is widely applied to the ground, to avoid the emergence of various adverse phenomena, the choice of materials is particularly important. The thickness of quartz stone should be more than 20mm, and the manufacturer should explain the use of the ground when buying because the formula of quartz stone floor tile is different from other application fields. On binder should abandon the use of traditional cement paste and should choose special rubber powder. Due to the smooth surface of quartz stone, it is necessary to avoid the separation of late and binder, and the adhesive should be brushed before paving.
1, rubber powder mixing, the ratio of rubber powder and water should be 1 water 4 dry powder, according to the construction habit can change the proportion of powder and water, adjust the thin consistency. Use a low-speed (300r/min) electric stirrer to stir the dough evenly.
2, glue, 2 hours before the paving, brush glue on the back of the quartz stone, glue needs to be completely transparent can be used.
3, After confirming that there is no clear water and dust on the base surface, scraping quartz stone adhesive (strip shape/full batch scraping) with the thickness of more than 7mm-15mm, the same way with quartz stone back, the thickness is 2-3mm, and then paste quartz stone, gently knock with a rubber mallet, so that the new quartz stone can be completely closed with the adhesive. Then correct the joint between the level and the adjacent plate and pay attention to the joint between the stone should be reserved 3mm or more.
Leave A Comment